How to polish the lights?
Every vehicle in the processoperation carries enormous loads. As a result, some parts are destroyed and worn out. If you take, for example, the headlights, then on their surface over time, you can see cracks, scrapes and chips. Because of this, the "eyes" of the car become clouded. In order to remedy this situation, you need to know how to polish the lights with your own hands. The polishing process does not take you very long and does not require much effort. At first, it should be noted that the headlights can be made of both plastic and glass. Depending on the material of their manufacture, the polishing process will depend.
How to polish plastic lights
To polish the plastic headlights you will need: water, polish, sponge, gloves. Before starting work, it is necessary to glue the body around the headlamp with paint tape. This will help to avoid damage to the car paint. In order to remove the scotch, do not tear along with the paint to spread a spot under the tape with oil. Now it is necessary to wet the surface of the headlamp with wet sandpaper, thereby removing all chips and scratches. When the surface of the headlamp is flat and matte, wipe it with a dry cloth and dry it. Then you need to thoroughly wash the water with a polishing sponge so that there are no fine grains of sand on it. After that, the sponge should be squeezed out, but not completely, but so that there are no visible drops of water on it. Now it is necessary to apply a small amount of polish on the sponge and start polishing the headlamp in slow circular motions. Periodically, you should moisten the sponge so that it does not scratch the surface. When the entire polish disappears, you will need to flush the headlight and dry it. In case of detection of dull spots on the surface of the headlights, it is necessary to polish this place again. If the headlamp shines like new, you can start polishing it with abrasive polishing. Use it follows the same technology as the main polish. At the end of the polishing process, the headlamp must be washed with water. By the way, try to handle more accurately with plastic headlights, because they are more fragile and thin.
How to polish the glass of a headlight
In order to polish the headlights made ofglasses will be needed: polishing for finishing, abrasive material of various granularity, paint tape, clean rag. First, you should carefully clean the headlights and wait a while for the surface of the headlamp to dry. Then you need to remove all the details that prevent further work. After this, it is necessary to cover with paint tape all the places that are adjacent to the treated headlight. Now you need to make the first grinding. It is performed using a circle with a grain of 600. In doing so, do not forget to moisten the abrasive wheel in order to improve the quality of work and not leave inside the headlights dirt. After this, it is necessary to carefully inspect the surface of the headlamp - it must be matte. Then the headlamp needs to be washed with water and a second grinding with a circle with a grain size of 1000. Then you should take a circle with the graininess of 2000 and perform the same manipulations. And in the end you need to polish the headlight around the grain size of 4000. If you managed to achieve the desired result, then the surface of the headlamp will be almost transparent by the time the work is done. The final stage of the polishing process is the use of finishing. To do this, apply a clean cloth and polish the headlight. At the end of the work you need to collect the material and do not forget to remove the adhesive tape from the body parts. Then you need to attach the parts that were removed at the beginning of the procedure.
We hope you understand how to polish your headlightscar, and were able to make sure that you can do it even at home. If you are scared to do all these manipulations at home, then it's worth contacting your official service, they'll do everything in the best possible way.