How to paste a film on a tablet?

The screen of the new tablet pleases with its smoothness andbrightness. But over time, there are stuck dust, scratches and stains. But you can protect your gadget from this, just stick a protective film on it. To make it look neat, and under it there were no air bubbles, you should know how to stick the film on the tablet.

Paste the film on the tablet

In order for the film to be glued perfectly, this followsdo in a clean room, as well as pre-prepare a napkin and any sharp object, better squeegee. Also, before gluing, you need to wash your hands. If there is an old film on the screen of the tablet, then before gluing a new one, it must be removed, having pierced its end with a sharp object.

So, before you glue the film on the tablet,wipe his screen with a tissue, completely removing dust, dirt, grease, fingerprints and stuff from it. The screen should be absolutely clean and shiny. In doing so, do not use any liquid to clean the screen, best suited napkins for LCD monitors. Now, when the screen shines with cleanliness, you can get the film out of the package.

As you can see, it is protected on both sidestransport protective coating, which is equipped with stickers for ease of use. These films are numbered: Layer # 1 and Layer # 2. Protective layer number 1 should not be completely removed, it is necessary to begin to glue the film from the wide and straight part of the screen. It is necessary to distinguish carefully the shipping tape №1 1/5 and align the tape along the edge of the screen. It is important to stick the protective film on the tablet so that dust and dust do not get under it, and if possible avoid touching the open part of the film with your hands. As the sticking layer to be gradually separated №1, gradually smoothing film. Be careful not to put the edge of the film under the edge of the screen. It is necessary that from each edge of the screen there is an interval of about 0.5 mm. If you can not immediately apply the film smoothly, then you can carefully remove it and repeat the operation.

After the separation of Layers No. 1 and completely gluingfilms on the screen can be separated by Layer # 2. If there are air bubbles under the film, they can be removed with a squeegee, "chasing" them towards the nearest edge of the film. All is ready. After that, wipe the screen with a tissue and use the device. Often happens, such a situation, that the first time to paste the film was not exactly possible, and under it got dust. Do not run to the store for a new one, it should be removed and washed with water, dried and glued again. Just do not try to stick a wet film, because in this case there is a huge risk of water getting into the tablet, which will lead to its breakage.

Now you know how to stick a film on the tablet, and you can protect your gadget from external influences. Typically, the film lasts at least a year.

Related news

How to paste a film on a tablet

How to paste a film on a tablet

How to paste a film on a tablet

How to paste a film on a tablet

How to paste a film on a tablet

How to paste a film on a tablet

How to paste a film on a tablet

How to paste a film on a tablet

How to paste a film on a tablet

How to paste a film on a tablet

How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet How to paste a film on a tablet